initial push

echo-rf-tool/echo-rf-tool.ino

@@ -0,0 +1,56 @@
+/*
+* Demo for RF remote switch receiver.
+* For details, see RemoteReceiver.h!
+*
+* This sketch shows the received signals on the serial port.
+* Connect the receiver to digital pin 2 on arduino and digital pin 1 on ESP8266.
+* Detected codes example:
+ Code: 8233372 Period: 273
+ unit: 1
+ groupBit: 0
+ switchType: 0
+*/
+
+#include <NewRemoteReceiver.h>
+
+void setup() {
+  Serial.begin(115200);
+
+  // Initialize receiver on interrupt 0 (= digital pin 2) for arduino uno, calls the callback "showCode"
+  // after 1 identical codes have been received in a row. (thus, keep the button pressed
+  // for a moment), on esp8266 use on interrupt 5 = digital pin 1
+  //
+  // See the interrupt-parameter of attachInterrupt for possible values (and pins)
+  // to connect the receiver.
+
+  // if you don't see codes try to reset your board after upload
+  
+  #ifdef ESP8266
+    NewRemoteReceiver::init(5, 2, showCode);
+  #else
+    NewRemoteReceiver::init(0, 2, showCode);
+  #endif
+  Serial.println("Receiver initialized");  
+  Se
+}
+
+void loop() {
+
+}
+
+// Callback function is called only when a valid code is received.
+void showCode(unsigned int period, unsigned long address, unsigned long groupBit, unsigned long unit, unsigned long switchType) {
+
+  // Print the received code.
+  Serial.print("Code: ");
+  Serial.print(address);
+  Serial.print(" Period: ");
+  Serial.println(period);
+  Serial.print(" unit: ");
+  Serial.println(unit);
+  Serial.print(" groupBit: ");
+  Serial.println(groupBit);
+  Serial.print(" switchType: ");
+  Serial.println(switchType);
+
+}